Can I apply more than two coats?

No, if you apply a third coat, there's a good chance it won't adhere.

What is the drying time for Hardwax-Olie Rapid?

4 to 6 hours at approximately 20°C and 50% relative humidity. At lower temperatures or higher humidity, drying takes longer. The product must dry naturally. Therefore, ensure good ventilation at all times, so make sure to open windows and doors after treatment.

Why do cloths saturated with Osmo need to be rinsed?

Cloths used for applying or polishing Osmo must be rinsed with water because they pose a risk of spontaneous combustion. Therefore, always rinse cloths with water before disposing of them in the trash.

Can I also treat MDF, veneer, and OSB?

Yes, all these surfaces can be treated with Hardwax-Olie.

Can I also touch up spots?

Yes, for localized scratches or worn areas, you can tape off the affected plank and sand it with 120 grit. Then check if the plank is even. If so, you can apply a new coat of Hardwax-Olie. If the plank requires a coarser sanding, you can start with 40 grit, then 80 grit, and finish with 120 grit. Then you can apply two coats of Hardwax-Olie.

Can I correct mistakes during application?

Mistakes that occur during application can be touched up on the wet surface up to 15 minutes after application. This includes roller marks or brush bristles.Once the surface has dried, mistakes can also be repaired locally. Tape off the affected plank and sand it with 120 grit. Then, apply a new coat of Hardwax-Olie. After 20 minutes, buff away any excess product along the grain of the wood.

When can floors treated with Osmo Hardwax-Olie be accessed again, and when can I put my furniture back in the room?

Newly treated surfaces can be accessed once the Hardwax-Olie has dried for approximately 24 hours. Furniture with legs that allow air to circulate underneath can also be put back after approximately 24 hours. Items that do not allow air to circulate underneath, such as rugs, should not be placed on the floor for two weeks until the Hardwax-Olie has fully cured.

Blik Osmo Hardwax-Olie Rapid van 0,75 liter

Quick-drying
Stain-resistant

Osmo Hardwax-Oil Rapid

Name: Osmo Hardwax-Oil Rapid
Brand: Osmo
SKU: 10300093
Price: 50.95 EUR
Availability: InStock
Rating: 5 (5 reviews)

3232, Clear satin matt / 0,75 litre

Safe for humans, animals and plants
Unique oil and wax combination
Dries in 4 to 6 hours

Variant

3232, Clear satin matt 3262, Clear matt 3240, White transparent

Volume

per 0,75 litre

covers approx. 23 m², about 2,22 per m²

Safe payment with

Order today, delivered tomorrowOrder before 4:30 pm and get it delivered tomorrow
Free delivery from €75
Need help?Read our DIY advice!

Frequently bought together

Osmo Rollerset 25cm

Large surfaces
For telescopic handle

~~28,85~~

Osmo Kwast

Small surfaces

From

Osmo Wisch-Fix 8016

Won't dry out
Daily cleaning

From

Osmo Vloeibare Onderhoudswas

Refreshes finish
Removes stains

From

Description

Osmo Hardwax-Olie Rapid 3232 semi-matt and 3262 matt provide colourless protection for wooden floors and stairs, as well as walls and ceilings. Suitable for most wood species, such as oak, pine, spruce, beech, ash and maple. Not suitable for walnut or for dark hardwoods rich in extractives such as wenge, merbau and jatoba: for these we recommend Osmo Blanke Was. This finish dries faster than Hardwax-Olie Original Colorless. Rapid is an oil- and wax-based product, which provides a protective surface after treatment. The product uses a two-layer system: the first layer is fully absorbed into the wood, while the second layer hardens in the upper pores of the wood. The surface appearance is very natural, as the product emphasizes the color of the wood. By wetting the untreated wood, you can get an impression of the appearance after treatment with Osmo Hardwax-Olie Rapid 3232 and 3262; a permanent wet look is created after treatment. This applies when using only Hardwax-Olie Rapid. Applying a color first and then a coat of Rapid to the wood won't create a wet-look effect. Thanks to the short drying time of approximately 4 to 6 hours per coat, you can apply the two coats in quick succession.

There is also a white version of Hardwax-Olie Rapid, 3240. This version has the same color as Hardwax-Olie Farbig 3040, but dries faster.

Hardwax-Olie Rapid Fast-Drying
Hardwax-Olie Rapid is the fast-drying version of Hardwax-Olie Original and should therefore be applied in exactly the same way. In two days, with two coats, you can treat the wooden surface with Osmo Rapid, making it completely ready for use. Each coat of Hardwax-Olie Rapid has a drying time of 4 to 6 hours.

Read here how to maintain a floor treated with Hardwax-Olie Rapid. Proper maintenance of a wooden floor extends the life of the treatment.

1L is sufficient for approximately 24 m² with one coat.

Osmo Tips & Tricks. Watch the video about preventing streaks; this ensures an even finish on the wood.

Note: For surfaces already treated with Osmo or another brand or product, always perform a test first. For renovations, it is always recommended to apply a maximum of one coat. If more than one coat is applied, there is a chance that the second coat will not adhere, making it easy to scratch off. You can find instructions on how to perform a test in the frequently asked questions.

Note: Cloths saturated with the liquid product should be washed immediately after use or stored airtight in a metal container (risk of spontaneous combustion). Once dry, the cloths can be disposed of in the trash.